A finned tube is a heat transfer device consisting of many parallel metal fins commonly used for heat dissipation and cooling applications. Finned tubes increase the surface area of the pipe, thus increasing the heat transfer efficiency. Finned tubes are commonly used in applications such as air coolers, automotive radiators, condensers, and evaporators. They are also used in industrial heaters and refrigerators to increase heat transfer surface area and improve efficiency.
Finned tube is a kind of new, wear-resistant, efficient heat exchange material, is a kind of energy-saving heat exchange element, it uses high-frequency power source as heat source, the steel strip, steel pipe heating at the same time, so that the fusion welding together into one, with high heat exchange efficiency, large cooling area, long service life, adapt to a wide range of temperature, high pressure characteristics, it can also be made of a variety of materials, Excellent heat transfer, durability, heat resistance and corrosion resistance. Widely used in waste heat recovery, petrochemical, power plant boiler, economizer, bus, industrial and civil construction heating, refrigeration, medical drying, wood drying, food drying system and other industries.
The main business scope is various heaters, waste heat boilers, pressure vessels, supportingair preheaters, air coolers, furnace accessories and accessories, and provide equipment installation, with EPC ability of projects. At present, our customers have covered all large and medium-sized petrochemical enterprises in China and established long-term strategic cooperative partnership with them. Products are exported to Southeast Asia, Middle East, and other regions.
Finned Tubes,Heat Exchange Finned Tube,Finned Tube Heat Exchanger,Heat Exchange Spiral Finned Tube Jiangsu Gelan Environmental Technology Co., LTD , https://www.glkj2010.com
Flat gate valve by driving can be divided into manual flat gate valve, pneumatic flat gate valve and electric flat gate valve. According to the purpose and use occasions can be divided into a diversion orifice plate gate valve, no diversion orifice plate gate valve, oil field plate gate valve, pipeline flat gate valve and gas flat gate valve. Gate valve can not open the fault condition Introduction Gate valve can be installed in the horizontal pipe or vertical pipe, single and double gate valve should be installed in the horizontal pipe, and the hand wheel should be located above the valve, not allowed to install down. Gate valve medium flow direction is not limited. Gate valve common fault analysis is as follows: 1, T-slot fracture (casting or machining failure) 2, the gate stuck 3, the internal screw nut corrosion failure 4, the valve stem is closed after the top heat 1, allowed to open more than Upper dead point 2, closing force appropriate, not allowed to use long levers 3, the correct selection of media 4, the operation of the corresponding unloading provisions to prevent heat top 5, T-slot fracture (over the top dead center, still vigorously Open operation